发信人: sobt(好懒)
整理人: reynolds(2001-11-08 08:48:10), 站内信件
|
这些题目是精华版没有的
102. Given the configuration example
interface ethernet0
ipx network 4a
ipx access group 800 out
interface ethernetl
ipx network 3d
interface ethernet2
ipx network 5c
!
access list 800 permit 3d 4a
Which two actions result from implementing this configuration? (Choose
two)
A IPX network 5c will not receive any traffic
B Traffic from network 3d for network 4a will be forwarded out e0
c Traffic from network 4a for network 3d will be forwarded out e0
D Traffic from network 3d destined for network 4a will be forwarded
out e2
E The access list is applied to an outgoing interface and filters outbound
traffic
Answer: B, E
103. Which two commands show your access lists? (Choose two )
A show filters
B show access- lists
c show ip access- lists
D show running- config
Answer: B, D
104. Which two steps are required to confound and apply standard access lists
on an interface? (Choose two )
A define an access list number and its parameters
B enable an interface to become part of the access list group
c define the number of access lists to be supported on an interface
D copy the access list definition to each interface that will support
it
Answer: A, B
105. What does the command show access- lists 101 1ist?
A all defended access lists
B all access lists within the router
C the contents of standard access list 101
D the contents of extended access list 101
Answer: D
106. What is a back off on an 802.3 networks?
A It is latency in store and forward switching
B It is the time used for token passing from machine to machine
C It is the retransmission delay that is enforced when a collision occurs
D It is the result of two nodes transmitting at the same time The frames from
each transmitting device collide and are damaged
Answer: C
107. What are four ways that Fast Ethernet compares to 10BaseT Ethernet? (Choose
four )
A Fast Ethernet uses the same Maximum Transmission Unit (MTU)
B Fast Ethernet is based on an extension to the IEEE 802.3 specification
c Fast Ethernet uses the same Media Access control (MAC mechanisms)
D Fast Ethernet preserves the frame format that is used by 10BaseT Ethernet
E Fast Ethernet errors a speed increase one hundred times that of the
10BaseT Ethernet
Answer: A, B, C, D
108. How many collisions are caused by transmitting and receiving frames
simultaneously in a full- duplex Ethernet technology?
A one
B two
C none
D several
Answer: C
109. What does the term Base refer to in 100BastT
A cabling type
B sloughing type
C 100 mode type
D spectrum used
E speed category
Answer: D
110. Which show underrate serial 1 status statement indicates that the shutdown
command was issued on that interface?
A Serial 1 is up line protocol is up
B Serial 1 is up line protocol is down
C Serial 1 is down line protocol is down
D Serial 1 is administratively down the line protocol is down
Answer: D
111. Which keystroke allows IOS to complete a partial command entry?
A <Tab>
B <CtrL R>
C <Spacebar>
D <Right Arrow>
Answer: A
|
|